Colloidal silver
Magnetic pulser
Complete bundle
Support EN

A zapper is only as good as its electrodes

For the overall performance of a Beck Zapper, the electrodes have at least the same importance as the zapper electronic circuit itself. Dr. Beck didn’t use standard electrodes, because their profile exceeds the area of the blood vessels.

According to Dr. Beck, the contact area of the zapper electrodes should be compatible to the width of the vessels (have about 1/8 inch or 3 mm width) and not exceed a certain length (3 cm), because otherwise the dissipative currencts become too strong. (inefficient currenct, due to decreased focus).

Electrode gel is THE medium for assuring a good electric contact. It is absolutely skin neutral. Salt, which has also been used by Beck in his Zapper prototypes, can irritate the skin and corrode the electrode surface very fast. You are always free to house the electrodes additionally in cotton, but we don’t recommend it, because of leakage into tissue.



A) gold plated miniZAP® special electrode with vessel compatible cross section

B) conventional Beck zapper brass or copper electrodes with circle cross section

Electric current concentrates in the artery.

Elektric currenct is dispersed dissipatively throughout the tissue.



Question: If the electrodes are on the same wrist, wouldn’t the electricity will pass at skin level and not go down into the tissues because electricity will take the shortest route and the electrodes are next to each other?

Answer: Not quite so: The blood vessels are right below the skin. When the pulse is chosen for electrode placement, the current goes directly into that vessel’s blood stream. The electrodes don't sit next to each other, but 3.5 to 4.0 cm apart. As one needs to concentrate the electricity on a small area, the electrodes have vessel shape.



Gold is resistent against almost all acids, even hydrochloric acid. Only aqua regia, a mixture of hydrochloric acid and nitric acid, can dissolve gold. This is the reason why the miniZAP® uses gold. Regardless, whether salt water or electrode gel or anything else is used - the surface doesn corrode or oxidise, in contrary to the brass and copper electrodes.